ASROCK K10N78HSLI-1394, Installation Manual

Page: 20 / 224

2 0 2 0
2 0 2 0 2 0
ASRock K10N78hSLI-WiFi / K10N78hSLI-1394 Motherboard
the red-striped side to
Pin1
EnglishEnglishEnglishEnglishEnglish
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2/3, No. 23)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2/3, No. 8)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors These six Serial ATAII
(SATAII_1 (PORT0):
(SATAII) connectors support
see p.2/3, No. 16)
SATA data cables for internal
(SATAII_2 (PORT1):
storage devices. The current
see p.2/3, No. 13)
SATAII interface allows up to
(SATAII_3 (PORT2):
3.0 Gb/s data transfer rate.
see p.2/3, No. 18)
(SATAII_4 (PORT3):
see p.2/3, No. 12)
(SATAII_5 (PORT4):
see p.2/3, No. 10)
(SATAII_6 (PORT5):
see p.2/3, No. 11)
SATAII_6 (PORT5) connector can be used for internal storage device
or be connected to eSATAII connector to support eSATAII device.
Please read “eSATAII Interface Introduction” on page 26 for details
about eSATAII and eSATAII installation procedures.
SA
T
AII_1
S
A
T
AII_3 SA
T
AII_5
(PORT0)
(PORT2) (PORT4)
SA
T
AII_2
S
A
T
AII_4 SA
T
AII_6
(PORT1)
(PORT3) (PORT5)