ASROCK G41M-LE, User Manual

Page: 13 / 118

1 3 1 3 1 3 1 3 1 3
ASRock G41M-LE Motherboard
EnglishEnglishEnglishEnglishEnglish
2.3 Installation of Memor 2.3 Installation of Memor
2.3 Installation of Memor 2.3 Installation of Memor
2.3 Installation of Memory Modules (DIMM) y Modules (DIMM)
y Modules (DIMM) y Modules (DIMM)
y Modules (DIMM)
G41M-LE motherboard provides two 240-pin DDR2 (Double Data Rate 2) DIMM slots,
and supports Dual Channel Memory Technology. For dual channel configuration, you
always need to install two identical (the same brand, speed, size and chip-type) memory
modules in the DDR2 DIMM slots to activate Dual Channel Memory Technology. Otherwise,
it will operate at single channel mode.
1. It is not allowed to install a DDR memory module into DDR2 slot;
otherwise, this motherboard and DIMM may be damaged.
2. If you install only one memory module or two non-identical memory
modules, it is unable to activate the Dual Channel Memory
Technology.
Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1. Unlock a DIMM slot by pressing the retaining clips outward.
Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
The DIMM only fits in one correct orientation. It will cause permanent
damage to the motherboard and the DIMM if you force the DIMM into the
slot at incorrect orientation.
Step 3. Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.