ASROCK AM2NF3-VSTA, User Manual

Page: 12 / 112

1 2 1 2
1 2 1 2 1 2
ASRock AM2NF3-VSTA Motherboard
EnglishEnglishEnglishEnglishEnglish
2.3 2.3
2.3 2.3
2.3 Expansion Slots Expansion Slots
Expansion Slots Expansion Slots
Expansion Slots
(PCI Slots and AGP Slot) (PCI Slots and AGP Slot) (PCI Slots and AGP Slot) (PCI Slots and AGP Slot) (PCI Slots and AGP Slot)
There are 5 PCI slots and 1 AGP slot on AM2NF3-VSTA motherboard.
PCI Slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AGP slot: The AGP slot is used to install a graphics card. The ASRock AGP slot has
a special design of clasp that can securely fasten the inserted graphics
card.
Please do NOT use a 3.3V AGP card on the AGP slot of this
motherboard! It may cause permanent damage! For the voltage infor-
mation of your AGP card, please check with the AGP card vendors.
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
Step 1. Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
Step 2. Remove the system unit cover (if your motherboard is already installed in
a chassis).
Step 3. Remove the bracket facing the slot that you intend to use. Keep the
screws for later use.
Step 4. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5. Fasten the card to the chassis with screws.
Step 6. Replace the system cover.