User Manual
HS589
To assemble the scooter, you can repeat the disassembly directions in reverse.
Abbreviated directions are given below. Refer to the figures on pages 12-13 to locate
the parts.
1.Using the tiller angle adjustment, unfold the tiller in an upright position. Place the front
basket on the tiller.
2.Hold the seat post and align the Curved Locking Brackets
(Z) on the front frame assembly with the bar on the rear
frame assembly.
3.While holding the seat post, slowly pivot the rear frame
assemby forward until the release lever locks.
4.Attach the main wire harness.
5.Place the two batteries and use the Velcro strap to secure
them in place.
6.Attach the battery cable plugs.
7.Place the rear shroud on.
8.Attach all rear lighting harnesses.
9.Place the storage cover on.
10.Install the seat by pulling the seat rotation lever up to allow the seat to drop into the
locked position.
11
Figure 26
(X)
Figure 27
Figure 28
(Y)
Figure 29
RE-ASSEMBLING YOUR SCOOTER
(Z)
Figure 30
(B)
(A)
Batteries must be charged before using the scooter for the first time and should be
recharged after each day use. You will need the scooter and the battery charger.
1.Insert battery charger cord into the charger connector on
the charger output. Refer to above figure for correct position.
2.Plug the other end of the battery charger cable into a standard
electrical outlet.
3.Turn the power on. Normally, The LED (Power) Light will turn on when electric current
passes.
Each country may supply different charger. The
charging procedure may be different from below.
If you require more details, please contact your
authorized dealer.
Be sure the scooter key is in the OFF position
CHARGING THE BATTERIES
Summary of Contents for MIDI HS588
Page 1: ...USER MANUAL HS589 MOBILITY SCOOTER MIDI...
Page 19: ......