24
25
8. CLEANING
To ensure all infection control protocols are strictly adhered to, it is extremely important to follow the below
steps to keep the product clean at all times.
Pump
• Wipe with a damp cloth that has been pre-soaked with a mild detergent.
• Ensure pump is kept free of dust and other particles.
DO NOT!
Immerse or soak the pump at any time.
Mattress Cover
• To remove small spills or stains, wipe the mattress cover with a damp cloth that has been
pre-soaked with a mild detergent or single use disinfectant wipe.
• To remove large spills or stains, the top cover should be completely removed and laundered as
per below procedure:
1. Remove top cover by unzipping all 4 x sides from the mattress base.
2. Prewash top cover at up to 95
°
for 15 minutes.
3. Main wash top cover at up to 95
°
for 15 minutes.
4. Dry mattress cover prior to use by hanging up on a line/air dryer or on a low heat setting it can
be tumble dried for up to 90 minutes.
5. Once dry, reattach top cover by zipping all 4 sides back onto the mattress base.
DO NOT!
Use phenol based products.
WARNING!
After cleaning, the mattress must be completely dried prior to use.
WARNING!
Do not dry mattress cover in direct sunlight to prevent wearing out of text on cover.
WARNING
WARNING
9. MAINTENANCE & STORAGE
To ensure longevity of your Alternating Mattress Replacement, it is very important that it is correctly stored
and regularly maintained.
General
• Check mains power cable and plug for any abrasions or excessive wearing.
• Check mattress cover for signs of wear or damage.
• Check air hoses for any kinks or breakages .
Fuse Replacement
• Disconnect the mains power if there is a blown fuse.
• Remove the cover on the side casing of the pump.
• Remove old fuse and reinsert a new fuse, fix in place with the cover.
WARNING!
Only use fuse supplied by your Aspire Dealer, ensuring it has the correct rating and
specification.
Air Filter Replacement
• Remove the cover on the rear casing of the pump.
• Remove old filter and reinsert a new filter, fix in place with the cover.
NOTE:
If the filter does not require replacement, it can be cleaned by being washed gently with a mild
detergent and warm water. Ensure the filter is dry prior to installing back into the pump.
WARNING!
Only use filter supplied by your Aspire Dealer, ensuring it has the correct rating and
specification.
Storage
• Release all air from mattress by
OPENING CPR
valve and disconnecting the mattress hose from the
pump.
• Lay the mattress out flat & roll from
HEAD
end towards
FOOT
end.
• Tighten mattress straps into clamps to prevent mattress unrolling.
• Packing strap can then be stretched around the rolled mattress to prevent unrolling.
WARNING
WARNING
Summary of Contents for ACTIVE AIR 8
Page 16: ...30 31 NOTES...