7
UVR-HE Series
7. INSTALLATION AND COMMISSIONING
WARNINGS AND PRELIMINARY OPERATIONS
• Check the perfect integrity of the various components of the unit.
• Make sure to have the accessories for installation and the documentation.
• Transport the packed section as close as possible to the installation area.
• Do not stack tools or weights on the packed unit.
• Place the unit on a solid structure that does not cause vibrations and is able to withstand the weight of the machine.
• Place the unit in a place where the condensate discharge can easily take place.
• Do not place the unit in rooms where flammable gases, acidic, aggressive and corrosive substances are present that can irreparably
damage the various components.
• In order to make installation and routine and extraordinary maintenance possible, provide a minimum free space to connect fittings,
channels and accessories.
• Provide false ceilings or walls that allow full inspection of the machine so as not to interfere with the maintenance operations.
• The air ducts must be sized according to the system and the aeraulic features of the unit fans. An incorrect calculation of the ducts
causes power loss or the intervention of any devices on the system.
• We recommend using insulated channels to prevent condensation and to reduce the noise level.
• We recommend placing an anti-vibration joint between the ventilation openings and the channels to avoid transmitting any machine
vibrations into the environment. However, electrical continuity between the channel and the machine must be guaranteed by an
earthing cable.
MACHINE POSITIONING
The units are equipped with support plates.
Position the machine correctly according to the position of the plates.
1
Plug
2
Rubber shock absorbers
3
Screw with washer
4
Insulated flexible/duct
5
Inlet/outlet connections
6
Recovery unit body
7
Terminal board box
8
Anti-vibration joint for duct
9
Condensate discharge
10 Recovery unit cover
Figure A
10% max
2
3
4
8
5
9
10
7
6
5
4
3
2
1
1
In order to favour the regular flow of condensation,
we recommend installing the machine at a 3 mm
angle towards the condensate discharge.
