36
set as “JPEG” in
Video Format
page. When an event (Motion Detection) is triggered,
this device will take a snapshot with JPG format.
Pre and Post Record Time Setting
Configure the record time for the event recording file. For example, if set “Pre Alarm”
as 3 seconds and set “Post Alarm” as 5 seconds, when an event (Motion Detection) is
triggered at time 10H:05M:10S, the video will be recorded from 10H:05M:07S to
10H:05M:14S.
Note:
Limited by the built-in RAM of this device, when data is too much or video
quality set too high, it will cause recording frame drop or decrease the recording
time of post alarm.
To avoid the “frame drop” situation, please reduce the bitrate of the video. We
recommend connect the device in LAN (Local Network) and set the video as
CBR, and Bitrate less than 1.5Mbps.
Network Disconnection Detect
After enable the check box of “Record Video into SD Card”, when the wire network is
disconnected, it will save the video into local SD card.
Note: When this event is happen, the frame rate of live video and recorded video will
be limited to 5FPS. The interval of two video files recorded on SD card is fixed
with 30 seconds.
Specific IP Detection
For the use of recording software, this device supports the detection of the connection
of this device and PC. Whenever the connection is disconnected, it records the video
to local SD card to make sure the video recording is continuous.
Detect IP – Enable / Disable:
Select to enable or disable this function.
IP Address:
The IP address or URL of the PC which installed the recording software.
