Thorough examination and test:
Recommended twice yearly or after damage. To be done by a person trained or qualifi ed in electrical and mechanical enginee-
ring.
- Isolate the power source to the machine. Observe electrical safety precautions.
- Disconnect the SENTIR edge from the control unit
- Inspect the SENTIR edge and components thoroughly for mechanical damage.
- Test the SENTIR edge operations.
- If the inspections tests performed reveal any problems, do not allow use of the machine until they are rectifi ed. Record the
inspection and test in a written log.
The sequence of examination operations varies at different applications. The trained staff is responsible for the correct se-
quence of examination operating in terms of safety.
TAMPERING WITH COMPONENT PARTS WILL INVALIDATE WARRANTY.
In the event of problems contact the supplier.
4. Precautions (General)
- Always adhere to the local and national electrical code specifi cations when wiring SENTIR edge and other controls. Wire the
SENTIR edge into controls as specifi ed by the control manufacturer.
- The safety regulations issued by the Trade Association and those for electrical installation must be considered. Failure to
comply with the safety regulations may result in severe or fatal injury or serious damage to property.
- Be sure to disconnect all power to the operator before installing the SENTIR edge.
- The gate or door must be in the fully opened or closed position before installing the SENTIR edge.
- Install correctly and test the SENTIR edge for proper operation.
- Do not operate equipment without a properly working and correctly wired SENTIR edge attached.
Warnings and disclaimers
To avoid the risk of crushing, Safety gloves must be worn!
Installa� on and electrical work must be performed by authorized electricians.
To avoid the risk of crushing, Safety gloves must be worn!
Installa� on and electrical work must be performed by authorized electricians.
13
