PRODUCT INFORMATION
Warnings and disclaimers
1. Preparations / set up
All SENTIR edges are inspected and tested before being shipped to ensure against damage. If the shipping container appears
to be damaged, please notify the supplier immediately.
WARNING:
Do not bend or fold as damage may occur.
2. Handling / Storage
To avoid the risk of crushing, Safety gloves must be worn!
Recommended:
- Ideal storage and temperature -25C to 75C (or if different per edge)
- Ideal storage: Dry, clean and fl at
- Transport SENTIR edges in the supplied packaging to where they are to be installed.
Not Recommended:
- Signifi cant bending of SENTIR edges
- Storing SENTIR edges vertically
- Extreme temperature fl uctuations
- Outdoor storage
- Pulling SENTIR edges by the cable
- Stack up SENTIR edges without packaging
3. Maintenance
- If damage occurs, such as brittle or torn rubber profi le, non-tight switching chamber, insuffi cient contact resistance in
the activated state or similar, the SENTIR edge must be replaced immediately.
- During the maintenance operations, disconnect the machine’s prime mover before working in the SENTIR edge system.
Observe all applicable electrical safety precautions.
- Cleaning: The profi les should be kept clean of deposits such as swarf (fi ne metallic fi llings or shavings removed by cut-
ting, grinding or any other mechanical process), debris, and other foreign materials to prevent damage or dead-zones. It
is permissible to use warm water and a mild detergent to clean the surface of the area.
- Important: Do not use solvents
- Stop the machine, clean the profi les and allow them to dry off. Inspect the surface of the profi le for the damage.
Any damage that punctures the profi le could let material or liquid in. It must be dealt with immediately. Check that all
endcaps, corners and joints are secure and free from damage. Damaged parts must be replaced immediately.
- Test the profi le operation. If these checks reveal any problem, do not allow use of the machine until the problems are recti-
fi ed.
To avoid the risk of crushing, Safety gloves must be worn!
Installa� on and electrical work must be performed by authorized electricians.
12
13
