16
Customer Care Center, 1-800-898-1879, www.askona.com
INSTALLATION
See the separate installation instructions included in the
set of documents.
ELECTRICAL INSTALLATION
Connect the machine by plugging it into an earthed wall
socket. The electrical wall socket must be placed outside
of the installation area to be easily accessible.
CONNECTION ON DELIVERY
• 208-240 V, 1-phase, 15 A
• 60 Hz
• Heat output 3000 W
• Use a type A residual-current device.
SWITCH-OVER
The switchover must be performed by a qualified
electrician.
1. The switchover must be performed by a qualified
electrician.
2. Press and hold the Temperature selection button and
then press the main power switch.
3. Turn the programme selector and choose between:
Heater 2 On (3000 W/15 A) and Heater 2 Off (1950
W/10 A).
4. Press the Start button once to save your selection.
WARNING !
Risk of fire.
Install the clothes dryer according to the manufacturer’s
instructions and local codes.
Do not install a clothes dryer with flexible plastic
venting materials. If flexible metal (foil type) duct is
installed, it must be of a specific type identified by
the applience manufacturer that is UL approved for
use with clothes dryers. Flexible venting materials are
known to collapse, be easily crushed, and trap lint.
These conditions will obstruct clothes dryer airflow and
increase the risk of fire.
To reduce the risk of of severe injury or death, follow all
installation instructions.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
POSITIONING THE TUMBLE DRYER
The tumble dryer can be freestanding or stacked.
Remember that the tumble dryer produces heat and
should therefore not be located in a room that is too small.
If the room is very small, drying will take longer due to the
limited quantity of air.
WARNING !
• Clothes dryer installation must be performed by a
qualified installer.
• For proper ventilation, the machine should not be
installed behind a door.
• The tumble dryer’s toe kick ventilation must not be
blocked by a rug or the like.
NOTE!
If the unit must be installed behind a door, the door
should be louvered. (please see door ventilation
requirements in the Built-in chapter). To improve
ventilation, the door where the tumble dryer is located
should be left open when the dryer is in use.
Freestanding
The tumble dryer can be positioned beside the washing
machine.
Stacking
The tumble dryer can be placed on top of a ASKO
washing machine. In this case you use the stacking
attachments (foot cups and anti-tilt devices) that come
with the machine. Two rubber feet and two anti-tipping
brackets are supplied in the bag found in the drum of the
dryer.
INSTALLATION
