Asko D5526XLFI, Operating Instructions Manual

Page: 14 / 20

Action Possible causes Problem
Press and hold Start/Stop until the display
shows (the door open symbol). This
indicates that the dishwasher is ready to start.
The Start/Stop start button has been pressed
for too short a time.
The dishwasher does not start.
Check. The door is not properly closed.
Check. A fuse/circuit breaker has been tripped.
Check. The plug is not plugged into the power outlet.
Check. The water supply valve is turned off.
Check. Overflow/leaks.
Turn off the water supply valve. Pull out the
plug and call the Customer Care Center.
A whirring sound (the drain pump) is heard
from the dishwasher and does not stop when
the power is cut with the On/Left-on mode
button.
Loosen the drain hose from where it termi-
nates. Check that no debris has clogged the
hose. Is the cone-shaped part of the drain
boot cut to the maximum size of the fitting
where it attaches?
Blocked drain hose. Water remains in the dishwasher above the
filters.
Check that the hose is free from kinks and
sharp bends.
Kink in drain hose.
Clean the coarse and fine filters. The filters are blocked.
Clean the drain pump. See the section Care
and maintenance instructions.
Debris in the drain pump.
Clean with dish brush and low foaming
cleaner.
Dirt around the seals and in corners. Bad odor in dishwasher.
Run a program with a higher temperature
about once a month.
Low temperature programs have been select-
ed for a prolonged period.
Activate the Long dry option. Drying power too low. The dishes are not dry enough.
Fully load the dishwasher. The dishwasher is not fully loaded.
Top up with rinse add or increase the rinse
aid dosage. See the sections Before washing
for the first time and Settings.
Rinse aid needs topping up or dosage is set
too low.
Open the door a little once the program has
finished.
Check that the baskets are correctly posi-
tioned horizontally.
The baskets are not correctly positioned. Cannot close door.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Wait a moment then try again. You have pressed the touch buttons too soon
after opening the door.
The touch buttons do not react when
pressed.
Clean with a dry or slightly damp cloth. Dirt on the touch buttons.
Open the door until the display illuminates or
close the door and wait 30 seconds. Then
open the door.
If this symbol appears on the display,
the door is not open enough.
See the section Settings. Child lock (button lock) activated.
14