Asko D5132, Use & Care Manual

Page: 30 / 36

0
Suggestions on positioning the
dishwasher
The dishwasher can be built in, fully freestan­
ding or semi­freestanding.
CAUTION!
Connection to electricity, water and drainage
must be carried out by a suitably qualified per­
son.
A. Built-in
The dishwasher can be built in under a worktop
with a working height of 820 ­ 870 mm. The width
measurement must be at least 600 mm. For ad­
ditional measurements, see picture.
B. Freestanding
A freestanding dishwasher must be fitted with anti­
tilt. This comprises two fastening irons which are
screwed into place as illustrated.
The dishwasher is then pushed in so that the
fastening irons grip onto the rear feet. The
dishwasher cannot now tilt in the event a load is
placed on the open door. If the dishwasher is to
be fully freestanding, both side panels and the
work top should be fitted. These accessories
can be purchased where you purchased the
dishwasher.
C. Semi-freestanding
If the dishwasher is positioned so that either side
is visible, a side panel can be fitted.
These accessories can be purchased where you
purchased the dishwasher.
D. Machines with wooden door
Stronger door springs are available for purchase
for machines with a fitted wooden door. Springs
are available for various weights and sizes of
wooden door. Door springs can be purchased
from the retailer who sold you the dishwasher.
Built-in installation
455-475
600
413
Freestanding installation
CAUTION!
A fully freestanding dishwasher must be fitted
with anti­tilt.
Tip!
A machine with side panels and a counter top
(freestanding) can, of course, also be installed
as a built­in unit.
Installation
Min 823
Min 560
600
135-18
5
50
50-105
596
820-870
520
560
With nut and sliding protection mounted
Recommended measurements
**
*
*
**
* *
100-
150