Asko D3530XL, Use And Care Manual

Page: 32 / 36

32
Screw the dishwasher into place
The enclosed plastic plugs are used for cov-
ering the screw holes if the dishwasher is to
be screwed at the sides. After fi xing check
that the front feet are in contact with the fl oor.
Fitting strip seal
(on fl oor plinth covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping with
both hands under the plastic plinth (A), and lift
outwards and upwards.
2. Undo the two screws on the covering plate
(B).
3. Glue the accompanying rubber strip (C) to
the underside of the covering plate (against
the fl oor).
4. Screw the covering plate back into place.
Adjust the covering plate so that the rubber
strip is just in contact with the fl oor.
5. Replace the plastic plinth
Slide the dishwasher into place
• Pull the drainage hose and connection
pipe when the machine is pushed into
place.
• Check that the hose has no kinks or sharp
bends, and check that there is nothing that
can damage the hoses.
Installing the plinth (kick plate)
The dishwasher has two kick-plates (some
models).
The taller one should be used if the machine
is to be 850 - 870 mm high and the depth of
the plinth can be varied between 45 - 105
mm. The lower one
is to be used if the
machine will be 820
- 845 mm with a
plinth depth of be-
tween 50 - 105 mm.
Attach the enclosed
felt insulation to the
kick-plate (some
models).
Set the correct plinth depth as follows:
1. Bring the grey hooks towards each other
and pull out the brackets as far as required.
Press in the catches so that they lock the
brackets in place.
2. Suspend the kick-plate from the brackets
by pushing into the slots.
A
B
x x
x
C
Not all models