background image

13

Customer Care Center, 1-800-898-1879, www.askousa.com

DRAINING THE CONDENSATE

The moisture from the laundry is extracted in the condenser unit and accumulated in the condensate tank. 

Condensate tank has to be emptied regularly (see chapter "CLEANING AND MAINTENANCE").

To simpli

fi

 ed and avoid emptying and interruption of the drying cycle due to full condensate tank, run the 

condensate discharge tube located at the back of the appliance directly into a drain.

A

1

Remove the small short hose from the attachment 

(A).

max 1000 mm

max 300 mm

max 300 mm

B

C

D

2

Connect the supplied drain hose to the same 

attachment (A).

Run the condensate drain hose into a drain. Tie the 

hose onto a tap (B) so that it cannot slip during use. 

The drain hose can also be fed into the washbasin 

siphon (C) or directly into the 

fl

 oor drain (D).

Then, the water is pumped directly into a washbasin, a 

siphon, or a 

fl

 oor drain.

  Do not pull the drain hose, and make sure it is not 

under tension, clamped, or bent.

  If you decide to run the condensate drain hose into a drain, siphon, or washbasin, make sure the hose is 

securely fastened. This will prevent any water spillage that could result in unexpected damage.

  Always use hoses that are supplied with the appliance.

  If the dryer is connected to an air exhaust system already used for another appliance, a non-return valve 

must be installed. Return 

fl

 ow into the dryer could damage the appliance and the non-return valve prevents 

such 

fl

 ow.

Summary of Contents for Classic T208H








Reviews: