Ask Proxima Impression 750, User Manual

Page: 9 / 45

USER GUIDE LCD PROJECTOR
8
5 SETTING UP THE LCD PROJECTOR
Switch off all equipment before connecting the components. Be aware of
static electricity that may build up, especially in the dry season and when
operating on synthetic carpets. Discharge any static electricity by touching
a metallic surface before you start.
Check for correct mains voltage before powering the projector
(see label close to mains input connector).
Do not cover the air inlet in front or the air outlet on top of the
projector housing as this will block the cooling. A thermal safety
switch will cut off the illumination system if the ventilation is
reduced.
Place the LCD projector on a table at a suitable distance from the
projection screen in order to get the desired size of the projected image on
the wall. Adjust the projection lens for a sharp image by turning the
focusing wheel on the lens barrel. Project on a flat surface screen with high
reflectivity to get a bright and undistorted, rectangular image.Best results
are obtained in a dimmed room with no direct sunlight shining in.
Switch off all equipment before you connect the LCD projector to
the computer, mouse and video source as outlined in the
following chapters. Then apply power first to the LCD projector,
then to the computer and video source for correct operation.