43
Setting
On start
Enable the projector to be turned on automatically just by connecting the AC power cord to an
outlet when this function is set to On.
Standby mode
This function is available when operating the projector via network.
Normal ...... Supply the power to the network function even after turning off the projector. You can
turn on/ off the projector via network, modify network environment, and receive an
e-mail about projector status while the projector is powered off.
Eco ........... Select Eco when you do not use the projector via network. The projector’s functions of
network, RS-232C and MONITOR OUT will stop when turning off the projector.
Cooling fast
This function provides the following options in the cooling fans’ operation after turning off the
projector.
Normal... Normal operation.
60s ........ Faster and lounder than Normal, cooling time is shorter.
0s .......... Enable you directlt unplug the AC power cord after turning off the projector, no need
waiting for cooling.
High land
Enable to control the fan through the Setup menu.
You can select the running speed of the fan according to the altitude of the location where the
projector is installed.
Off......Normal speed. Set it so if the projector is operated at a lower altitude.
On......Faster than Off. Set it so if the projector is operated at a higher altitude because fans will
produce weaker effects.
Ceiling
This function is used to project the image from a ceilingmounted projector.
On.......The picture will be top/bottom and left/right reversed.
Auto.... The projector automatically identifies its vertical or inverse state.
Off ......Disable this function.
Lamp control
Change the brightness of the screen.
Normal ... Normal brightness.
Auto........ Adjust the lamp brightness according to the input signal.
Eco ... .....Lower brightness, reducing power consumption and extending the lamp life.
Test Pattern
This function is used to set the internal test signal.
