-3-
UNPACK AND INSPECT
Remove the packing from the appliance and inspect for any damage. Ensure that the bricks are positioned
correctly and not broken (see illustration for proper brick arrangement). Make sure that the baffle board, above
the air tubes, is in place and undamaged. DO NOT remove the baffle board.
TOOLS AND MATERIALS NEEDED FOR INSTALLATION
A 7/16” socket wrench
A 5/16” socket (Best if using a power drill and a socket bit)
A pair of pliers or channel-locks
A power drill with an 1/8” drill bit to install sheet metal screws into connector pipe.
Sheet metal screws
A non-combustible floor protector as specified in this manual
All chimney and chimney connector components required for your particular venting installation.
PRE-ASSEMBLY
Brick Configuration
ASSEMBLY
ASSEMBLY INSTRUCTIONS
Read and follow the directions in this manual to ensure proper assembly, installation and operation of your new
wood heater.
Caution! The appliance is very heavy.
The assistance from a second person is strongly suggested. Please use proper lifting technic when positioning the
appliance for assembly and installation. Several methods may be used to attach the legs and pedestal to the
appliance. The safest method is to roll the appliance on its back. When using this method, you should first remove
the firebrick from the unit so as to reduce weight and possible breakage. It will be required to raise the bottom
of the unit up to attach two of the legs. It is recommended that you use cardboard or other means of padding
to protect the finish on your new stove.
FREESTANDING LEG ASSEMBLY
1. Unpack the stove and ensure all components are present:
2. Position the unit for assembly.
3.
Make sure that the fire brick is in place and undamaged. DO NOT remove the fire brick.
