Ashford Handicrafts Limited
Factory and Showroom: 415 West Street
PO Box 474, Ashburton 7700 New Zealand
Telephone 64 3 308 9087 Facsimile 64 3 308 8664
Email: [email protected] Internet: www.ashford.co.nz
1
Attach the base rail (with the Ashford logo) to one side and one foot and secure with a
washer and knob. Note the metal bracket faces out and the tapered side fits snugly into
the tapered rebate in the foot. Tighten the knobs to make the joint tight.
2
Secure the top rail to the same side with a washer and knob.
3
Attached the other side and foot. Secure with a washer and knob.
4
Completely unthread the side knobs on the Knitters Loom. Remove the steel washers and replace
them with the thin rubber washers. Partially thread the knobs back on. Slide the loom onto
the metal brackets keeping the rubber washers between the loom and the brackets. Tilt the loom
to a convenient weaving angle. Lift the back of the loom to engage the 2 L blocks, check the reed
support blocks are upright and tighten the side knobs.
washer & knob
bottom rail
foot
sides
washer & knob
washer & knob
washer & knob
top rail
metal brackets
rubber washer
rubber washer
