6
x
5
x
5
Hook the drive belt over
the back flyer bearing
and hang it between the
2 wheel support rails.
Position the wheel
between the 2 wheel
support rails.
CHECK:
The smallest
groove in the wheel is
towards the front of the
Spinner.
Position the other side onto the wooden
dowels in the ends of the 5 rails. Then
loosely attach all 5 rails with 50mm (2”)
bolts and barrel nuts. Support the wheel and
carefully lay the Spinner on its back to attach
the treadle rail. Sit the Spinner back on its
feet on a level surface.
CHECK:
The top and wheel support rails are
parallel with the legs. Then tighten all bolts.
NOTE:
If the flyer “ticks” as it rotates, loosen
the 2 bolts securing the front top rail and
twist it about 1 degree forwards from vertical.
This ensures the ends of the
steel split ring slide smoothly
past the top of the bearing.
