ASEKO s.r.o., Vídeňská 340, 25242 Vestec u Prahy
Tel. 244 912 210
Fax 244 910 800
http://www.aseko.cz
The operating life of the electrodes
The electrolytic cell is made of titanium coated with a special layer of ruthenium and iridium. During the electrolysis
this layer is consumed. The life of the electrolytic cell depends on the following parameters:
Water pollution
Water temperature
Salt content
Output
The life of the electrolytic cell is reduced by:
Low content of salt
Water temperature below 10°C
Low water flow
Too hard water
The pH level under 7.5
Cleaning of the electrodes
During the operation the electrodes are gradually polluted by deposits from hard water which must be perodically
removed. The clogging of the electrodes causes the output decrease, i.e. at unchanged salt content the current
decreases (observed by the numbe
r of lit diodes on the fromt panel). In this case the systém must be switched off,
electrodes taken out and for about 10 minutes plunged into the solution for the electrodes cleaning. The whity
coating should disappear and the electrodes can be returned back.
Maintenance
Neither ASIN Salt nor the electrolyzer TE13 require any maintenance. However, both device are situated in a
corrosive environment and therefore it is necessary to check, eventually clean the elctric connections.
The electrolyzer must be kept in the temperare above zero,
water inside may in no case freeze!
Ocupational safety
ASIN Salt may operate persons without electronic qualification.
Removing covers and exchanging any of the machine’s parts is forbidden. To clean the machine, use a cloth
dampened with water or detergent. Use ethyl alcohol to remove stubborn stains. The use of other organic solvents
is forbidden, as well as the use of any cleaners that would cause abrasion of the surface of the plastic case or the
front cover.
Persons working with Asin Salt must be informed that using the machine in a manner not intended by its
manufacturer can render ineffective the electrical safety features of the device.
!!! WARNING !!!
All of the chemicals used for water quality treatment are caustic. Do not allow them to come in contact with
your skin! Wear rubber gloves and work with all due care when refilling chemical supplies and when
changing pump tubes. Stains on clothing from these substances will cause irreparable damage! Always
obey the safety instructions for the individual chemicals (see the safety sheets) when handling them or
performing repairs.
Guarantee
The manufacturer is liable for defects of the ASIN Salt equipment and electrolytic cell for 2 years from the date of
sale. If this date is not credibly evidenced, the guarantee period starts on the production date indicated on the pro-
duction label.
The manufacturer is not liable for defects caused by the operation of ASIN Salt in contradiction with the manual as
well as for defects caused by inexpert installation of the equipment.
