ASE 2000, Owner'S Manual

Page: 10 / 26

All Seasons Equipment |Owner’s Manual - 2000 Hydraulic Swing Hoist 10
Installing/Connecting the Power Unit and Power Pack
1. Position the Hydraulic Winch into the retainer brackets on Rear Frame Leg #3.
2. Insert pin (#14) through the Rear Frame Brackets and tubes at the back of the Winch. Then insert hitch pin
(#16).
3. Our Gas Power Pack comes equipped with four 9ft hoses which have quick connect couplers on one end. The
three larger quick connects are to be attached to the Hydraulic Winch Unit.
NOTE: The Quick Connect Couplers are all different sizes. It is impossible to connect them in the wrong position.
4. There are two remaining hoses to connect. These are the hoses with the two smallest quick connect
couplings. These connect to the Hydraulic Cylinder (#18).
NOTE: When the Hydraulic Hoist is not in use or being transported, the Hydraulic Cylinder Shaft should always be
retracted to prevent damage to the shaft.