ASE 2000, Owner'S Manual

Page: 12 / 26

All Seasons Equipment |Owner’s Manual - 2000 Hydraulic Swing Hoist 12
WARNING:
Always keep in mind the maximum rated load on the hoist you are using.
3. The fence on the Vertical Frame must be swung outward to protect the operator from accidentally walking
off the roof edge while operating the hoist.
4. Check the hoist cable for broken strands. If any are found, the cable should immediately be replaced before
operating the Hoist.
5. Check the hoist braking system for proper operation. Always test the hoist with a small amount of weight
before lifting heavy objects.
6. Grease all moving parts on the hoist frame regularly. Failing to grease bearings and pulleys is the leading
cause of machine failure.
7. The hydraulic oil level must be checked every day before operation. If the oil level is too low, top it up with
10W40 Motor Oil.
8. If the hydraulic oil is repeatedly low, check for leaks in the system and repair immediately.
9. Engine oil should be checked daily before starting. For all other engine maintenance, refer to engine manual.
2000 Single 2000 Double 1500 Double
Double Line Capacity with
200ft Cable.
---------- 2000 lbs 1500 lbs
Single Line Capacity with
200ft Cable.
2000 lbs 1600 lbs 1000 lbs
Operating Instructions
Hydraulic Power Pack Operation
1. Lever #1: Lifting and Lowering Load Control
- Push lever forward to position B to lift material (Or wind cable)
- Pull lever backwards into position A to lower material (Or unwind cable)
2. Lever #2: Swing Cylinder Control
- Push lever forward to position B to swing lift boom in towards the roof top
- Pull lever backwards into position A to swing lift boom out over the roof top.
WARNING: Operate all controls slowly for
safety and to increase the life of the
machine.
3. Lifting Hook – Attach cable here when lifting
Power Pack.
4. Return Hydraulic Filter
5. Hydraulic Tank Filler Tube
6. Fluid Level Gauge