TD 93021US
17 July 2017 / Ver. PF3
80
Installation Guide
teleCARE IP
6.9
Toilet Cancel Module - Active (NITC-XXA)
Figure 105. Toilet cancel module (active)
The Toilet Cancel Module is designed for use in the teleCARE IP system. It is a wall mounted single switch
module used to cancel toilet calls made by linked toilet call devices.
Each room bus offers individual addresses for up to four switch modules. The address is of the active
toilet cancel module is fixed at number 4 and cannot be changed.
The toilet cancel module requires a single backplate which must be ordered separately. The backplate
enables this switch module to be mounted over different types of back-boxes. Alternatively, a spacer with
installation kit is available for surface mounting.
6.9.1 Toilet Cancel Module (Active) Electrical Connections
The toilet cancel module is an “active peripheral” therefore it must be connected to one of the four room
buses of a teleCARE IP room controller by the 4-pole room bus connector (see
).
The toilet cancel module also has a 4-pole connector for the passive bus to which a passive pull-cord call
module can be connected (see
6.10.1, Pull Cord Module (Passive) Electrical Connections on page 81
Note:
Only one passive pull cord switch module can be connected per passive bus.
Figure 106. Toilet cancel module electrical connections
4-Pole Connector
for Room Bus
4-Pole Connector
for the Passive Bus
