5
Man-down & No-movement alarm
Man-down alarm: The transceiver is tilted more than 55o for a
preset time.
No-movement alarm: Movement is not detected during a pre-set
time.
Before the alarm is sent, the transceiver enters a warning phase
with a repeated warning signal (default seven seconds). Press
any button during this warning phase to prevent the alarm from
being sent.
Note:
Man-down & No-movement alarm can temporary be
disabled (default 10 minutes). When the warning signal sounds,
press the Mute button. Press Yes when Delay MD/NM
Alarms? is shown in the display.
Note:
If enabled, the ramped up Acoustic Location Signal (ALS)
is played after an alarm. Press
the Mute button to turn the ALS
off.
Location function (IR or LF)
The location of the transceiver, received via either infrared light
(IR) or low frequency transmission (LF), is automatically sent
along with an alarm.
Note:
A transceiver with an IR receiver must never be covered.
Special location
If the fixed locators are set to send a special location code, the
transceiver will send an location alarm directly after it has
received the code. Special location sent is shown in the
display.
Alarm data
Press
, select
, select Alarm Settings and Alarm Data.
Type the alarm data and press Save. The saved data is sent
when an alarm is transmitted.
Deactivate/activate alarms
The Pull-cord alarm, Man-down alarm & No-movement alarm
can be turned off/on; Press
, select
, select Alarm
Settings. Scroll to the desired alarm using
. Press
to
deactivate/activate the alarm. Press
to leave the screen or
to return to idle mode.
Note:
The Alarm push-button is always enabled.
