2
Customer Care Center, 1-800-898-1879, www.askona.com
WARNING!
Risk of
fi
re.
Install the clothes dryer according to the
manufacturer’s instructions and local codes.
Do not install a clothes dryer with fl exible
plastic venting materials. If fl exible metal (foil
type) duct is installed, it must be of a specifi c
type identifi ed by the applience manufacturer
that is UL approved for use with clothes
dryers. Flexible venting materials are known to
collapse, be easily crushed, and trap lint.
These conditions will obstruct clothes dryer
airfl ow and increase the risk of fi re.
To reduce the risk of of severe injury or death,
follow all installation instructions.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
Positioning the tumble dryer
The tumble dryer can be freestanding or
stacked. Remember that the tumble dryer
produces heat and should therefore not be
located in a room that is too small. If the room
is very small, drying will take longer due to the
limited quantity of air.
NOTE!
• Do not install the machine in a room
where there is a risk of frost occurring.
At temperatures around freezing point
the machine may not be able to operate
properly.
• The room in which the appliance is installed
should be adequately ventilated, with
temperature between 15°C and 25°C.
WARNING!
• Clothes dryer installation must be
performed by a qualifi ed installer.
• For proper ventilation, the machine should
not be installed behind a door.
• The tumble dryer’s toe kick ventilation must
not be blocked by a rug or the like.
NOTE!
• If the unit must be installed behind a door,
the door should be louvered. (please see
door ventilation requirements in the Built-in
chapter). To improve ventilation, the door
where the tumble dryer is located should be
left openwhen the dryer is in use.
Freestanding
The tumble dryer can be positioned beside the
washing machine.
Stacking
The tumble dryer can be placed on top of an
ASKO washing machine. Use the two foot cups
found in the document bag included with the
machine and the two tip guards attached to
the bottom of the back of the machine.
How to assemble the stack:
1. Undo the screw on the back of the ASKO
washing machine as shown in the fi gure.
2. Secure the anti-tilt device using the screws
as shown in the picture.
3. Take the other anti-tipping bracket from
the bag and attach it on the dryer with two
screws as shown in the fi gure.
4. Place the two rubber feet on the front feet
of the dryer.
5. Fasten or undo the rear feet of the
appliance until it is fully level, either on the
fl oor or on the washing machine.
6. Slide the dryer backward until it reaches the
anti-tipping bracket. Make sure the front of
the appliance is raised by 50 to 150 mm as
you slide it back.
Adjusting the feet
Screw the feet in or out so that the tumble
dryer is steady and balanced on the fl oor or on
the washing machine.
