AT5200 FTTX Multiport EDFA
Solutions Provider for FTTx, RFoG, and HFC
www.ascentcomtec.com
Page 28 of 29
Any time the fiber leads to the amplifier are disconnected, there is the potential for
contamination of the ends of the fiber connectors. Dirt or other contaminants on these
components can reduce the amplifier’s performance and can result in permanent damage to
the device. It is recommended that the fiber connectors be cleaned prior to connection, or
reconnection, to the system.
No lights ON
Is the power on?
Is the fuse OK?
Pin fail ON
Is the optical input power too low?
Is the input connector dirty?
Pout fail ON
Check the optical output power and pump parameters on the LCD.
Contact ACT Technical Support.
Pump alarm ON
Check the pump parameters on the LCD. Contact ACT Technical
Support.
