Quickstart
Implementing a basic configuration
MAX 4000 Series Hardware Installation Guide
Preliminary November 4, 1998
3-43
LQM=No
LQM Min=600
LQM Min=600
Link Comp=Stac
5
These parameters can remain at their default settings.
6
Select IP Options.
The IP Options subprofile appears:
90-101
Ip options...
LAN Adrs=0.0.0.0/0
WAN Alias=0.0.0.0/0
IF Adrs=0.0.0.0/0
Preference=100
Metric=7
Private=No
RIP=Off
Pool=0
Multicast Client=No
Multicast Rate Limit=100
Client Pri DNS-0.0.0.0
Client Sec DNS=0.0.0.0
Client Assign DNS=Yes
7
If you are configuring a Connection profile for a device with its own IP address, set the
following parameters:
–
LAN Adr —Enter the IP address including any subnet mask, of the remote unit, then
press Enter to return to the list of parameters.
–
WAN Alias—If the far-end device is non-Ascend and requires numbered interfaces
with PPP encapsulation, enter the IP address of the remote unit’s WAN interface (not
its Ethernet interface), then press Enter to return to the list of parameters.
–
IF Adrs—If you are implementing interfaced-based routing on the MAX, enter the IP
address of the port used on the MAX side of the link.
8
If you are configuring a Connection profile for dynamic address assignment, set the
following parameter:
–
Pool—The IP address pool from which you want to assign this client an address. IP
address pools are configured in the Ethernet > Mod Config > WAN Options submenu.
9
Using the RIP parameter, specify how you want the MAX to handle RIP packets on this
WAN interface:
–
Off (the default)—The MAX does not transmit or receive RIP updates.
–
Recv-v1—The MAX receives RIP-v1 updates, but does not transmit RIP updates.
–
Send-v1—The MAX transmits RIP-v1 updates, but does not receive RIP updates.
–
Both-v1—The MAX transmits and receives RIP-v1 updates.
–
Send-v2— The MAX transmits RIP-v2 updates, but does not receive RIP updates.
–
Recv-v2—The MAX receives RIP-v2 updates, but does not transmit RIP updates.
–
Both-v2—The MAX transmits and receives RIP-v2 updates.
10 Press the Escape or Left-Arrow key until the confirmation menu appears, then press 2 to
save your changes.
