background image

 

 

5

asberprofessional.com

 

 

 

 

 

 

 

 

 

 

 

 

 

asberprofessional.com

 

 2.4 Gas Connections

 

 

The  gas  supply  (service)  line  must  be  the  same  size  or  greater  than  the  inlet  line  of  the  appliance. 
ASBER appliances use a ¾

” NPT inlet.  

Pipe joint compound must be resistive to Natural or LP gas. 

For  equipment  using  propane  gas  do  not  install  supply  lines  with  a  diameter  less  than  ½  under  any 
circumstances.  

All connections must be tested with a soapy water solution before lighting any pilots. 

The appliance shall be connected to the fuel gas for which it was designed. No attempt shall be made to 
convert  the  appliance  from  the  gas  specified  on  the  rating  plate  for  use  with  a  different  gas  without 
consulting  the  installation  instructions,  the  serving  gas  supplier,  or  the  appliance  manufacturer  for 
complete instructions. 

2.4.1

 

MANUAL SHUT OFF VALVE 

This installer supplied valve must be in the gas service line ahead of the appliance regulator in 
the gas stream and in a position accessible in the event of an emergency. 

2.4.2

 

PRESSURE REGULATOR 

Commercial cooking equipment must have a pressure regulator on the incoming service line for 
safe and efficient operation; the gas pressure regulator supplied by ASBER must be installed at 
the gas inlet of each piece of equipment. 

The  regulators  supplied  along  with  ASBER  appliances,  will  have  3/4

”inlet/outlet  openings  and 

are  adjusted  at  the  factory  for  5

”  WC  (natural  gas)  or  10”  WC  (propane  gas)  depending  on 

customer

’s ordering instructions. 

Prior to connecting the regulator, check the incoming line pressure, as these regulators can only 
withstand  a  maximum  pressure  of  ½

” PSI (14”WC). If the  line pressure is beyond this limit, a 

step down regulator will be required. 

The arrow shown on the bottom of the regulator body shows the gas flow direction, it should 
point downstream to the appliance. The BLUE air vent cap on the top is part of the regulator 
and should not be removed.

 

Any  adjustments  to  the  regulator  should  be  made  by  qualified  service  personnel  only  with  the 
proper equipment. 

2.4.3

 

THIS APPLIANCE IS EQUIPPED FOR NATURAL GAS. 

This  appliance  is  equipped  with  orifices  for  operation  with  natural  gas.For  conversion  to  LP 
(PROPANE) change the  orifice selected in the table according burner  type. Orifices necessary 
for  LP  (PROPANE)  conversion  are  provided  on  accessory  box.Gas  conversion  must  be 
performed by qualified or authorized personnel 

WARNING: To avoid the risk of serious personal injury or property damage, the range must be 
converted  correctly.  Improper  conversion  or  flame  adjustment  will  produce  carbon  monoxide, 
which is a poisonous gas. 

 

Summary of Contents for AECM-24














Reviews: