- 67 -
When configuring an access list, you can add multiple statements by adding criteria to the same numbered list. The
order of the statements is important, as the switch tests addresses against the criteria in an access list one by one (in
the order the statements are entered) until it finds a match. The first match determines whether the software accepts
or rejects the address. Because the software stops testing conditions after the first match, the order of the conditions
is critical.
Important!
You may not delete an individual statement from an access list; you must delete the entire access list and
re-enter it with new statements.
Important!
By default, if no conditions match, the software rejects the address.
The switch supports two types of access lists:
•
Standard
: access list numbers 1–99 and 1300–1999 (expanded range)
•
Extended
: access list numbers 100–199 and 200–2699 (expanded range)
5.6.1 Create a Standard Access List
Standard access lists filter at Layer 3, and can allow or block access to networks and host addresses. The
parameters for a standard access list are described as follows:
•
Access list number (1–99)
: Identifies the access list to which an entry belongs. There is no limit to how many
entries make up an access list, other than available memory
•
Remark
: Access list entry comment. This may be useful to keep track of numbered lists
•
Permit/deny
: Indicates whether this entry allows or blocks traffic from the specified source address
•
Source address
: Enter the source IP address to match
•
Any
: Specifies any source address to match
•
Source wildcard mask
: Identifies which bits in the address field are to be matched. A “0” indicates that positions
must match; a “1” indicates that position is ignored
In the following example, a standard access list will be created to allow all traffic from the 192.168.0.0 networks, while
blocking all non-192.168.0.0 traffic. The last entry is redundant, since the switch will deny access if there is no match
found by the end of the list.
Router#
configure terminal
Router(config)#
access-list 1 ?
deny Specify packets to reject
permit Specify packets to forward
remark Access list entry comment
Router(config)#
access-list 1 permit ?
A.B.C.D Source address to match. e.g. 10.0.0.0
any Any source address to match
Router(config)#
access-list 1 permit 192.168.0.0 ?
A.B.C.D Source wildcard. e.g. 0.0.0.255
<cr>
Router(config)#
access-list 1 permit 192.168.0.0 0.0.255.255
Router(config)#
access-list 1 deny any {0.0.0.0 255.255.255.255}
In the next example, a standard access list will be created to deny all traffic from 192.168.123.254 and allow all other
traffic to be forwarded. Note that the last entry of this example is not redundant, as it is a
permit
statement. An implicit
