Asada ROLL GROOVER 640, Instruction Manual

Page: 9 / 20

ROLL GROOVER 640
9
Preparation Before Operation
◆ Base Bracket that matches to the Threading Machine must be used.
Otherwise, it will not allow proper operation and may cause a damage to the machine.
◆ Install Base Bracket as the seal side comes in front.
Installing the opposite side may cause of overload and damage the machine.
◆ Tighten a screw of Connection Shaft to a flat surface.
To prevent from loosening and unstable rotation during the operation.
① Attach Base Bracket to Grooving Body.
Fix them by using Hex Socket Bolt M8 x25L
and 4 pcs of Spring Washer 8 in the standard
accessories. Required Base Brackets are
different depending on the Threading Machine.
Please use the suitable Base Bracket.
Applicable models are written on the back side
of Base Brackets. In addition, when installing
Base Brackets to the unit, make sure to install
it as the seal side comes in front.
② Insert Connection Shaft all the way into
Grooving Shaft.
③ Tighten two screws attached on Connection
Shaft to the flat surface and fix them.
Spring Washer 8
Bolt M8x25L
Seal Side
[BE50]
Grooving Shaft
Two Screws
Tighten
3
Connection Shaft
Insert
2
CAUTION
[BE80]
Seal Side
[BE100]
Seal Side