BEAVER 10
17
(6)Loosen the two Bolts of Blade Guide and the Lock Nut of Blade Guide Head, and turn the adjustment bolt clockwise
or counterclockwise to adjust the angle of the blade guide head.
*When the top length is larger: Turn the adjustment bolt counterclockwise.
*When the bottom length is larger: Turn the adjustment bolt clockwise.
*A half turn of the adjustment bolt allows adjustment of about 0.8mm. (For 4” pipe) Always adjust the blade guides F
and R to the same value. (After adjustment, always make sure that the end of the adjustment bolt makes contact
with the surface of the blade guide.)
(7)Install saw blade referring to
page 12
“
Replacement the Saw Blade
”
.
(8)Confirm the oblique cutting according to the procedure (1)-(4)
3) Daily Inspection and Maintenance
-Do not wet the motor with water.
*Immediately replace Power Plug, Power Cord and extension cord, if damage.
*Check the saw blade for chipping or damage. Replace if chipping is found. (For the saw blade replacing procedure,
refer to page 12
“
Replacement the Saw Blade
”
.)
<Fig.9>
Blade stopper
ball bearing
Adjustment Bolt
Back stopper
ball bearing
Washer
Stop Bolt
Blade guide
Lock nut
U nut
Summary of Contents for BEAVER 10
Page 23: ...BEAVER 10 22...
