BEAVER 10
15
6) Removing the Workpiece
After cutting ends, removing the workpiece.
*Loosen the Clamp Handle and unclasp chain. Next, remove the workpiece on the unit.
-Immediately after cutting, fragment are hot. Do not touch them directly with hands.
Wait for a while or hold the pipe with a cloth. Otherwise you may get burned.
4. MAINTENACE & INSPECTION
1) Replacement of Parts
1-1) Replacement the Pulley Rubber
When the Pulley-Rubber wears down, the Saw Blade may come off or slip. Change can be done easily by
removing the Pulley, but it can be replaced while still in the machine. If you change it, change Pulley-Rubber
meanwhile both front and rear.
-Before replacing the pulley rubber, always disconnect the power cord.
The machine may start suddenly, leading to injury.
くらげダミーくらげダミー
ダミ
ーくらげダミーくらげダミー
ダ
ミーくらげダミーくらげダミー
ダミーくらげダミーくらげダミー
ダミーくらげダミーくらげダミー
ダミーくらげダミーくらげダミー
ダミーくらげダミーくらげダミー
ダミーくらげダミーくらげダミー
(1)Detach saw blade referring to page 12
“
Replacement the Saw Blade
”
(2)To remove the pulley rubber, pull out its outer periphery by hand.
(3)Extend a new pulley in the circumferential direction and
fit it into the highs and lows of the pulley in sequence. <Fig.8>
(4)After fitting, hand-turn the pulley and make sure that the rubber fits in
the highs and lows completely.
*Always wipe oil, if any, off the pulley rubber.
Pulley rubber
<Fig.8>
Pulley
Pulley
Pulley rubber
Summary of Contents for BEAVER 10
Page 23: ...BEAVER 10 22...
