First time of the season and first use in a pool, a beach, a river ...
No Stress ! It’s simple !
Test procedure
Even all scenarios covered and tested with
No Stress
, a test procedure is essential at the beginning
of each season and for every new environment : pool, beach, river, pond, ...
Above all, read the rules of good practice with No Stress page 8.
To ensure No Stress is fully functional :
Turn on your smartphone and start
No Stress
application (see page 4).
Put a Beacon under surveillance (see pages 5-8) and close its holder.
Walk around the pool (the beach ... ...) with the Beacon, leaving your smartphone where it will be
during surveillance.
If no alarm is triggered, then the smartphone is well placed and the pool (the beach ...) properly
covered by
No Stress
.
If the alarm is triggered, then you should move your smartphone closer to the the pool (the beach
...) and restrict the secure area. To stop the alarm, press “Deactivate the alarm” on your smarthone
alert screen.
To ensure each Beacon and your smartphone are fully functional :
Activate each Beacon and put it under surveillance (see pages 6-8). Close its holder.
Immersion alert:
Immerse a Beacon under 10 cm of water : your smartphone triggers an immersion alert under 5
seconds. Remove the Beacon of the water and press “Deactivate the alarm” on your smarthone
alert screen to stop the alert. Repeat for each Beacon to be tested.
Opening alert of the Beacon holder:
Open the Beacon holder. Your smartphone triggers an holder opening alert under 2 seconds. Press
“Deactivate the alarm” on your smarthone alert screen to stop the alert.
If all test results are good, No Stress is ready for use.
© AS Pool
17
v. 1.3.0
An hesitation ? A doubt ? Contact us at [email protected]