AS 565KM
1.5.7 Storage
Before any longer storage (e.g. at the end of the season) clean any dirt or plant remains from the cutter. Prevent all unauthorised persons from
accessing the cutter. Protect the cutter from wind but do not use airtight protection, which can cause higher corrosion.
Check that the blades are intact and sharpen them (if damaged, exchange them).
We strongly recommend:
➢
Mothball the blades on the cutting disc.
➢
Remove all dirt and plant remains from the machine.
➢
Repair damaged places on colour parts.
➢
Empty petrol tank and carburettor (for further instructions see engine user manual).
➢
Carry out seasonal lubrication of the cutter according to
Table 5
➢
Check tyre pressure and fill the tyres to
MAX
level.
1.5.7.1 Machine washing and cleaning
Follow local laws protecting water courses and other water resources from chemical contamination when cleaning the cutter.
Never wash the engine with a stream of water! The electrical equipment of the engine might be damaged on starting the engine.
Do not use pressure washers for cleaning the cutter.
1.5.8 Package and machine disposal after its service life termination
You are required to carry out the package disposal after unwrapping the cutter, following national waste laws and regulations.
We recommend to follow these instructions when disposing of the machine after its service life termination:
➢
Dismount all machine parts that can still be used.
➢
Empty oil from gearbox and engine into an appropriate tank and hand it in at a collection point
➢
Dismount plastic and coloured metals.
➢
You are required to carry out the disposal of the dismantled machine remainder and dismounted parts, following national waste laws and
regulations.
30
Collection point information is given by responsible local office.
13