21
Adjusting cutting height
Adjust the cutting height setting only when the
engine is switched off.
Set the cutting height so that the blade does
not touch the ground even in case of terrain
unevenness. If the cutting height is set too
high, objects can be ejected and the “clean cut
appearance” can be destroyed.
The adjustment of the cutting height is per-
formed per axle.
If the scale shows the same position for both
axles, the blade is parallel to the mowing area.
Front axle
The cutting height adjustment of the front axle
is infinitely variable.
1. Switch off the engine and wait until the en-
gine comes to a standstill.
1
Fig. 5:
2. Turn the crank at the front axle until the de-
sired cutting height was reached.
ð
The lubricating nipple (
1
) shows the set po-
sition on the scale.
Rear axle
AS 62 4T B&S
The height on the rear axle can be adjusted to
5 positions.
1. Switch off the engine and wait until the en-
gine comes to a standstill.
2
1
2. Slacken the nuts (
1
) and remove the
screws (
2
).
3. Lift the device to the desired height.
4. Insert the screws (
2
) into the hole from the
outside.
5. Tighten the nuts (
1
) on the screws (
2
).
