Arzum MAXIBLEND GLASS AR 1056, Instruction Manual

Page: 18 / 52

18 ARZUM
Use of Chopper:
• Turn the chopper reservoir
by rotating the chopping knife
headpieces and place it on a
flat surface with the open side
pointing up
• Put the material to be
processed in the chopper
reservoir (approx. ≤100 g) and
lock the chopping knife headpieces (seal ring inside) firmly, then secure
it to the motor unit;
• Plug the power cord into a standard wall outlet;
• Turn the speed knob to speed 5 (usually about 30 seconds required),
depending on the job you will be doing.
When the desired effect is obtained, move the knob to position 0.
Note: For each use, the consecutive operation time must not exceed
30 seconds. Wait at least 10 minutes between two continuous cycles;
Wait for the unit to return to room temperature before performing the
next cycle of operation.
MAINTENANCE AND CLEANING
• Unplug the blender before cleaning.
• For easier cleaning, always wash immediately after use. Do not allow
food to dry in the glass jug, which makes cleaning difficult.
• Pour a little warm foamy water into the glass jug and set the knob to
position P for a few seconds. And then empty the glass jug.
• Remove all removable parts. Remove the glass jug unit from the
motor part, the knife base on the glass jug can not be removed, should
be cleaned together with the glass jug
• When removing the grinder reservoir and
chopper reservoir, first remove the reservoirs from
the motor base, then remove the grinder reservoir
knife headpieces and chopping knife pieces from
the grinder reservoir by turning them clockwise and
finally remove the gasket ring and the knife cap
group.