6
ARZUM
7
ARZUM
SETTING THE TEMPERATURE
• Before starting ironing with your Arzum Claro Steam Iron always check
first to see whether a label with ironing instructions is attached to the
article to be ironed. Follow these instructions, if any. If ironing instructions
are missing but you do know the kind of fabric, then the table given
below will be helpful for you.
NOTE:
1- If you have started ironing those fabrics that require higher
temperatures and if you wish to iron such fabrics requiring the lowest
temperature, then set the temperature switch from the position “ ” to the
position “ ”, and wait for 5 minutes to allow cooling down.
CAUTION: There is a thermal safety fuse to protect the steam iron from
over-heating. However; for your safety always disconnected your iron
from the electrical outlet after finishing the iron or before taking a rest.
DRY IRONING
• Place your iron on a flat surface and on its heel. Turn the temperature
switch to the position lowest temperature, i.e. “min”.
• Set the variable steam button to the position of no steam, i.e. “0”. This
will prevent the steam flow; even there is water in the water tank.
• Adjust the temperature switch according to the kind of fabrics you
want to iron.
• You can start ironing after the temperature display light disappears,
indicating that the selected temperature is being maintained.
NOTE: Pilot light may again turn on to maintain the selected
temperature of soleplate during ironing, which is suitable for the article
being ironed.
FILLING WITH WATER
(For steam ironing and spraying)
• Remove the mains plug from the wall socket before filling your iron, set
the variable steam button the position of dry, i.e. “0”.
• Open the water filling inletcover, with the iron held on an angle, pour
water slowly into the filling hole. Do not fill higher than indication “MAX”
of the water tank. After filling the tank then close the water filling inlet
cover.
• You can use tap water, unless it is very hard (hardness higher than
17º PH). Otherwise, it is advisable to use distilled water. However, the distilled
water must be subjected to an actual distillation process before filling.
EN
NOTE:
NOT SUITABLE FOR IRONING
MAX
MAX STEAM
LABEL
Synthetic
fabrics,
For example:
Acryl,c, viscous,
nylon,
(polyamide),
polyester
Linen
Cotton
Silk
Wool
MIN
DRY IRONING
“0”
TYPE OF
TEXTILE
TEMPERATURE
SWITCH
STEAM
