Aruba 303H Series Hospitality Access Point
| Installation Guide
9
Figure 9
Attaching AP-303H to Bracket
9. Once the access point is fastened onto the wall mount, insert the T8H Torx security screw into the hole
located on the upper-right edge of the wall mount and tighten.
10. If not using PoE, connect the AC-DC power adapter (sold separately) to the DC power socket located on the
bottom of the AP-303H.
Verifying Post-Installation Connectivity
The integrated LED on the Access point can be used to verify that the access point access point is receiving
power and initializing successfully (see
Table 1
). Refer to the
ArubaOS Quick Start Guide
for further details on
verifying post-installation network connectivity.
Electrical and Environmental Specifications
For additional specifications on this product, please refer to the product data sheet at
www.arubanetworks.com/safety_addendum.
Electrical
Ethernet:
100/1000 Base-T auto-sensing Ethernet RJ45 interface
IEEE 802.3u (100 Base-T). IEEE 802.3ab (1000 Base-T)
Power over Ethernet IEEE 802.3at 56VDC (nominal) and 802.3af 48VDC (maximum).
Power:
48VDC power interference, support powering through an AC-to-DC power adapter (AP-AC-48V36C)
Maximum power consumption with a full PoE-PSE and USB load: 25W (PoE) or 31W (DC)
Environmental
Operating:
Temperature: 0
°
C to +40
°
C (+32
°
F to +104
°
F)
Humidity: 5% to 93% non-condensing
Storage and transport:
Temperature: -40
°
C to +70
°
C (-40
°
F to +158
°
F)
If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed,
without an output rated 48VDC, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a
standard power receptacle in the US and Canada.
