Aruba Networks S2500 Series, Installation Manual

Page: 14 / 40

14 | S2500 Mobility Access Switch Aruba S2500 Series Mobility Access Switch | Installation Guide
Disabling the LCD Screen
By default, the LCD screen is enabled. However, if your S2500 is deployed in a location without physical
security, the LCD screen can be disabled through the CLI. When disabled, pushing one of the navigation
buttons will only illuminate the screen and display the slot, role, device name, and any alarms.
Additionally, it is possible to only disable the maintenance menu. This allows you to change the LED
behavior and view the device status but prevents upgrades and configuration changes.
To disable the LCD screen, enter the Enable mode and use the following CLI commands:
(S2500) #configure terminal
(S2500) (config) #lcd-menu
(S2500) (lcd-menu) #disable menu
To disable only the Maintenance menu or one of its sub-menus, enter the Enable mode and use the
following CLI commands:
(S2500) #configure terminal
(S2500) (config) #lcd
(S2500) (lcd-menu) #disable menu maintenance ?
factory-default
media-eject
quick-setup
system-halt
system-reboot
upgrade-image
upload-config
(S2500) (lcd-menu) #disable menu maintenance upgrade-image ?
parition0
partition1
10GBASE-X Port
Each S2500 is equipped with four 10GBASE-X ports. These ports are intended for use with Aruba SFPs.
SFPs are 10Gb hot-swappable, optical transceivers, which convert serial electrical signals to external serial
optical or electrical signals.
Media Eject Completes the reading or writing of the attached USB device.
 All: Media Eject [no | yes]
System Reboot Allows you to reboot the mobility access switch.

Standalone: Reboot [stack | local] [no | yes]

Primary: Reboot [stack | local] [no | yes]

Non-Primary: Reboot local [no | yes]
System Halt Allows you to halt the mobility access switch.
 Standalone: Halt [stack | local] [no | yes]
 Primary: Halt [stack | local] [no | yes]
 Non-Primary: Halt local [no | yes]
GUI Quick Setup Enables the quick setup mode for initial configuration. Pressing enter while this
option is selected will display
Quick Setup running .
Exit Maintenance Menu EXIT MAINTENANCE
Table 13 LCD Panel Mode: Maintenance
Function/Menu Options Displays