ARTURIA – Modular V – USER MANUAL
55
sequencer in a cyclic manner. This output is visible only visible at trigger input
menu level.
Sawtooth
Square
Triangle
Sinusoid
These oscillators are independently tuned with the “frequency” knob. This
button possesses a /- an octave per semi-tone setting with a left click
and a fine tune s/- a semi-tone with a right click.
The “range” selector allows the setting of oscillator range on 6 positions: Low,
32, 16, 8, 4 and 2. With the Low position the oscillator can be used at a very low
frequency (on a cycle of more than 6 minutes). The other positions set the
oscillator to octaves 1,2,3,4 and 5. That is to say the note C3 is played
respectively on C1, C2, C3, C4 and C5.
At the Low position the oscillators perform modulations using lower
calculation power than the other positions.
Two modulation inputs allow the separate setting of each of the oscillators in
the group. They are very useful for modifying the tuning between oscillators
thanks to a low frequency oscillator, a keyboard follow or other modulation
source.
Like the controller modulation inputs, they can be connected to the output of
another module. Connected to an oscillator functioning in the same audible
spectrum, they can obtain sonorities with FM characteristics.
A synchronization input and the associated interrupter allow the
synchronization of the slave oscillator on one of the other oscillators. In this
