Artistic License micro-scope 3a, User Manual, Page: 32 / 73

Artistic Licence Engineering Ltd. Micro-Scope 3a user guide
32 / 73
@
@@
Name Function
COL 1-7 Exercise the colours available. This tests up to seven
colour attribute channels of the lamp. Depending on the
lamp type, the order will be either:
RED BLUE GREEN COLOUR-WHEEL 1-4 or
YELLOW MAGENTA CYAN COLOUR-WHEEL 1-4
GOB 1-7 Run through all the available gobos.
STRB Test the Strobe effects.
ZOOM Test the Zoom.
FOCS Test the Focus.
IRIS Test the Iris.
PRIS Test the Prism.
EFFX Test the Effects.
AUX 1-7 Test a further seven attributes as defined in the lamp
library.
ALL Run all of the tests listed above in sequence. When the
ALL test is running, the display alternates between
‘ALL’ and the current attribute.
The DMX512 output continues when Micro-Scope is in Receive
mode. You can download a copy of Mic-Edit from the Artistic
Licence web site to inspect the detailed channel allocations for
each moving lamp.
TRANSMIT
DYNAMIC
DMX512
The TRANSMIT DYNAMIC
DMX512 selection allows any
range of dimmer channels to
be switched on at a level, or
ramp continuously. The following keys are active:

LEFT Decrement the end dimmer channel

RIGHT Increment the end dimmer channel
 UP Increment the start dimmer channel

DOWN Decrement the start dimmer channel

TOGGLE Stop or Start the channels ramping
Any range of dimmers can be controlled. The display shows the
start and end dimmer channel, followed by the current percentage
level.
The level ramp requires ten seconds to increment from zero to full
and then decrement back to zero.
If the end channel is set to a lower value than the start channel, all
output channels are set to zero.
The DMX512 output continues when Micro-Scope is in Receive
mode.