Page 6
DALI-Scope User Guide
y
PRESET: [CHANNEL / GROUP] – Preset
memory for either channel or group
-
UP or DOWN used to select value (0-
100%)
-LEFT or RIGHT used to select index
-LEFT (hold) then RIGHT used to select
between channel or group
Note: These presets are held in
memory.
STATUS
ADDRESS
Use the STATUS button to scroll through the
different sub menus below:
y
DALI BUS POWER: [OK/DALI PSU
PRESENT/NO PSU PRESENT]
y
BALLAST STATUS: [OK/ERR/NOT
PRESENT]
y
LAMP STATUS: [OK/FAILURE/NOT
PRESENT]
y
LAMP POWER: [ON/OFF/NOT PRESENT]
y
RESET STATE: [YES/NO/NOT PRESENT]
y
LIMIT ERROR: [YES/NO/NOT PRESENT]
y
VERSION NUMBER: [VERSION/
UNKNOWN/NOT PRESENT]
y
SHORT ADDRESS: [ADDRESS/
MISSING/NOT PRESENT]
y
CHANNEL ASSIGN: Used to change the
channel assignment of a ballast
-LEFT or RIGHT to select ballast to
program
-
UP or DOWN to select the new channel
index
-YES (and hold) to program ballast
-NO to cancel new channel index (before
programming occurs)
y
GROUP ASSIGN: Used to assign a ballast
to a group
-LEFT or RIGHT to select ballast to
program
-
UP or DOWN to select the new group
-
YES (and hold) to confirm action
-NO to cancel action (before programming
occurs)
y
GROUP REMOVE: Remove a group
assignment from a ballast
-LEFT or RIGHT to select ballast to
program
-
UP or DOWN to select the group
assignment that is to be removed
-
YES (and hold) to confirm action
-NO to cancel action (before programming
occurs)
y
SCENE ASSIGN: Store a value for a
scene within the ballast memory
-LEFT or RIGHT to select ballast to
program
-
UP or DOWN to change the scene level
-LEFT & RIGHT to select scene index
-
YES (and hold) to confirm action
-NO to cancel action (before programming
occurs)
y
SCENE REMOVE: Remove a scene value
from the ballast memory
-LEFT or RIGHT to select ballast
-
UP or DOWN to change the scene that is
to be removed
-
YES (and hold) to confirm action
-NO to cancel action (before programming
occurs)
y
AUTO CHANNEL ASSIGNMENT: Assign
short addresses to new ballasts
-
YES (and hold) to confirm action
Note: This function is for programming new
ballasts that have not been assigned a channel
number. It will reset ALL ballasts on the DALI
circuit and give them new channel numbers. If
you need to program a new ballast on a circuit
without affecting other ballasts, please isolate
the new ballast.