MELLES GRIOT
11
Main Rack and Controller
4.3
Configuring the Controller
4.3.1
Introduction
A configuration provides basic information about the system, (i.e., the modules used,
the stages connected, NanoTrak scan parameters etc.), which may be needed by
software applications that operate the system.
The system must be configured when it is set up for the first time, or when the
hardware is changed. The configuration program
MG17_Config
allows such
information to be entered and saved on the hard disk under a configuration name,
which is then specified at the beginning of a software application to enable the
information to be retrieved. Fig. 4.2 shows a typical configuration screen.
Fig. 4.2 MG17_Config configuration program
Several configurations, each with a different name, can be stored and called as
required. All configurations are stored in a single file called
Mg17_cfg.ini.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
