Matrix-500 User Guide
‧
14
‧
4.11 Enabled Serial Console Port
The serial console port is disabled as factory default setting. To enable the serial console, you need
to use the serial console cable (91-RJCON-100) and connect it to port 3. Use any terminal software
such as hyper terminal and setting as follow:
Baud Rate: 115200
Data bits: 8
Parity: N
Stop bit: 1
Terminal type: ANSI
The serial console port is disabled as factory default setting. To enable the serial console, you need
to purchase or prepare a serial console cable and connect it to port 3. Right after powering on the
system, keep typing $ continuously until you see the message as shown in the figure followed.
Console (ttyS0) stands for console port ttyS0 is enabled. Repeat this procedure will disable the serial
console and Screen will show “Console (null)”.
Summary of Contents for Matrix-500
Page 2: ......
