Aport-213 User’s Guide
ARTILA
30
6.5.3
Set a Virtual Serial Port
Click the [Setting] button to configure the virtual serial port.
The Virtual Port/Network Configuration supports following parameters that you can configure:
Parameter
Description
Connection Protocol TCP or UDP connection type
Remote Host IP
The target device server’s IP address
Remote Host Port
The target device server’s port number
Enable VCOM
Enable the virtual serial port sending and receiving flow control
packets. This function is dependent on the flow control function of
APORT-213 RS-233 to WiFi firmware. If this function is enabled on
virtual serial port driver and firmware, both sides will add a 3 bytes
header ahead of each egress WiFi packet and will strip off the 3 bytes
header of ingress WiFi packet.
Connect at Windows
Start
Enable / disable the automatic connection function at Windows start.
When this function is enabled, the virtual serial port will automatically
connect to the target device server after VSP COM port is opened.
Mode
Virtual port can run either on Client or Server mode. If the Server
mode is selected, Listen Port field must be configured a port number
accordingly. And the port number larger than 2000 is recommended.
