ArTi WH FLAT 50-100L, Instructions For Use Manual

Page: 5 / 34

arti.ua 5
EN
CONNECTION TO THE POWER GRID
1. The electric heater is supplied with connected electric cable which should be connected to
a fixed electric grid, according to the color of the wires. L - Phase conductor; color-black;
N - zero condictor; color-blue; conductor for grounding color yellow-green.
2. The connection of the water heater to the power grid must be done in accordance with the
standards for electric installations. Between the water heater and the permanent installa-
tion there must be built in a switch which will enable the distance of the contacts in the two
poles at an open position to be higher or equal to 3 mm. This is in accordance with the
national regulations for installing. This is a modern type of water heater with a thermostat
which enables you a comfortable use of the product. The thermostat consists of a regula-
tory and a protective thermostat.
3. On the control panel, there is a display and you can manually set parameters for working,
and the protective thermostat has a function to protect the whole product from overheating.
The same has a possibility for resetting, if the protection is activated. The handling and
setting of the thermostat can be learned only if you read the instructions in detail and if you
act according to the description given in it.
4. CONTROL PANEL
On the control panel you can read the following data:
1.1. The water temperature in Celsius degrees (˚C);
1.2 The temperature which is set;
2. Time
2.1. Hour
2.2. Time of postponed heating
3. Mode
3.1. Mistakes
3.2. Mode for postponed heating
3.3. Mode for heating
4. Time of postponed heating
4.1. Time of postponed heating turned on
4.2. Time of postponed heating turned off
5. Heaters
5.1. Heater 1 turned on
5.2. Heater 2 turned on
5. POSSIBILITIES OF THE DEVICE
5.1. By pressing button (SW1), (OFF/ON) which serves for turning on and turning off, a tone will
be heard and the LCD display will be activated. By turning on the display, you will see all he
func
tions which are described in “CONTROL PANEL” on it.
5.2. The button (SW2)(MENU) serves for moving through the display so that you can change
the needed parameters such as: temperature of the water in the water heater, the hour, time at
the beginning and at the end of the water heating, choice of heating with one or two heaters,
choice of a mode.
5.3. The button (SW3), (SETTINGS) serves for change of the parameters such as: Temperature
of the water in the heater for water, hour, time of beginning and end of heating, choice of heating
with one or two heaters, choice of type of heating.