39
AHLink
AHlink is used to control and set-up the unit.
By default, the AHLink wireless signal is deactivated. To activate it for the
D3 or D3R, please press and hold simulatenously the Open (1) and Close
(3) buttons on the cover plate for 5 seconds. You can also activate
the AHLink wireless signal by using the Interactive Setup Display (ISD)
located below the monitor. Press successively the Down arrow until the
AHlink appears on the LCD screen. Then, press the OK button and you
will hear a 5 Beep sound. This means that the AHLink is active.
To activate the AHlink signal for the DynamicTalk, press during 2 seconds
the Up and Down microphone button located on cover plate, or
contact close GPI2 pin to GND during 2 seconds. When the AHlink signal
is activated, it sounds 5 beeps inside the unit to indicate that the AHlink
signal is active.
The wireless AHLink signal
automatically deactivates when
there is no device connected
during more than 2 minutes.
When the AHLink deactivates,
you will hear a long Beep sound.
To control and set up your AH
product with AHLink, please
download it from the App Store
(IOS system) or from Google Play
(Android system) and execute it
in your handled device.
It is recommended on to select
Auto Connect and select Portrait
on Orientation. To connect it,
select Scan for local devices.
