LED WALL WASH LIGHT Introduction
Unpacking:
Thank you for purchasing our products. Every unit has been thoroughly tested and has been shipped in
perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If
the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to
operate the unit has arrived intact. In the case damage has been found or parts are missing, Save the carton and all
packing materials. In the event a fixture must be returned to the factory. It is important that the fixture be returned in
the original factory box and packing.
Introduction:
The unit is a DMX intelligent LED wall wash light. This light can be used in a stand alone mode or
connected in a Master/Slave configuration. The unit can also be controlled via DMX controller. This light has three
operating modes: stand alone mode, Master/Slave and DMX control mode.
AC Power:
This fixture has an auto-switching power supply that can accommodate a wide range of input voltages. The
only thing necessary to do before powering on the unit is to make sure the line voltage you are applying is within the
range of accepted voltages. This fixture will accommodate between 100V and 240V AC. All fixtures must be powered
directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit. Even if the rheostat or
dimmer channel is used solely for a 0-100% switch.
Safety Instructions:
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit.
• Be sure that the local power outlet match that of the required volt-age for your unit.
• Do not attempt to operate this unit if the power cord has been frayed or broken. Do not attempt to remove or break off
the ground prong from the electrical cord. This prong is used to reduce the risk of electrical shock and fire in case of an
internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user serviceable parts inside.
• Never operate this unit when its cover is removed.
• Never plug this unit in to a dimmer pack.
•Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6”(15cm) between this
device and a wall.
• Do not attempt to operate this unit, if it becomes damaged.
• This unit is intended for outdoor and indoor use, Don’t dip the products into the water. IP 65 rating.
• During long periods of non-use, disconnect the unit’s main power.
• Always mount this unit in safe and stable matter.
• Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or
against them, paying particular attention to the point they exit from the unit.
• Cleaning -The fixture should be cleaned only as recommended by the manufacturer. See page 3 for cleaning details.
• Heat -The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other
appliances (including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
Please read these instructions carefully, which includes important information about the installation,
usage and maintenance of this product.
