4
circuit, and even burn out parts of computer control panel.
3.
Power supply.
Using appropriative plug connect computer light and power main
lead. Pay attention to consistent of voltage, frequency and supply
source of backboard of computer light. Suggest each computer light
to use a separate power supply, so each light can be turn on and turn
off at will.
Important matters:
Each computer light should be earthed and whole electro
assembling must accord with standard demand.
The power consumption of computer light is 280W.
Monitoring restoration system:
After computer light switch on power, circuitry will be install. This
function makes lamp cobra moving to a limiting position, and it will
turn interior color and superimposed wheel of pattern. Thus the
control system of microprocessor can login all place of electrical
machines which controlled by it. It will bring electric noise in
computer interior, when modulator tube damage or burnout. Maybe it
will disturb normal operation of MPU. computer light has an
electronic monitoring system that can watch operation of MPU, and
ensure that will start up reinstallation function when it is disturbed.
After it finish, computer light can accept new control instruction and
operate without a hitch.
4.
Connection of control communication wire
Connection of controller and computer light or connection between
each computer light should use two-core shielded cable, and diameter
of each core should be o.5MM at least. When it joined in or come out,
it should be used cylindrical three-legged XLR plug and outlet which
L=Brown
E=Yellow/Green
N=Blue
