9
menu(page) quickly.
2.3.1 ADDR--> Address: Set DMX Address
Click and select the "ADDR", can enter the page of DMX address setting, range from 1 to 512, the
address code shouldn’t is not greater than (512- channels quantity), otherwise the light will not been
controlled. Following is the operation:
Enter the page of DMX address, as shown in Figure 7, click the blank area in right side of display will
pop-up dialog as in Fig.4, modify value, then click ‘ENTER’ to confirm and save DMX address code.
Figure 7 page of DMX Address
2.3.2 MODE--> WorkMode: Set Light work mode
Enter the page of ‘WorkMode’ as shown in Figure 8 and modify setting. Can set light work mode, control
lamp and DMX channel mode.
Figure 8 page of work mode
◆
DMX Ctrl
: Choose to set DMX Mode,
◆
Auto Run
: Choose to set Auto Mode,
◆
Sound Ctrl
: Choose to set Sound Mode,
◆
M/S Choose:
Available just in ‘AUTO RUN’ or ‘SOUND Ctrl’ mode.
ON--> Master. (Data will be sent to other slave lamp immediately.)
OFF--> Slaver. (NOT send data to other lamp via DMX Cable).(
Default
)
◆
Light Switch:
ON--> Turn on the light,
OFF--> Turn off the light.
◆
Channel Qty:
Light support 2 DMX Channel mode: sample or extend
。
Simple --> 18CH.(
Default
)
